[. . . ] Thoroughly inspect the area where the equipment is to be used and remove all objects which may be thrown by the machine. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot. If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapours have dissipated. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. [. . . ] WARNING: Before you leave the operator's position, move the shift lever to the neutral (N) position. Use the throttle/choke control (7) to increase or decrease the speed of the engine. Move the throttle/choke control (7) completely forward to the CHOKE position to start a cold engine. For normal operation and when using a grass bagger, move the throttle control to the FAST position. For maximum charging of the battery and for a cooler running engine, operate the engine in the FAST position. To change the cutting height, raise or lower the lift lever (5) as follows. Move the lift lever (5) forward to lower the mower housing and back to raise the mower housing. When you ride on a sidewalk or road, move the lift lever (5) to the highest position and move the blade rotation control to the DISENGAGE position. Before you start the engine, make sure the blade rotation control (1) is in the DISENGAGE position (8). To rotate the blade, move the blade rotation control (1) forward to lock the blade in the ENGAGE position (9). Before you leave the operator's position, make sure the blade(s) has stopped rotating. Daily or before each use After completion of first 5 hours After 25 hours For wear or burn out c. When you hold the blade, use gloves or cloth material to protect your hands. If you keep the blade (1) sharp and inspect the blade for damage, the blade will cut better and be more safe to operate. Frequently check the blade for excessive wear, cracks, or other damage. Before you operate the unit, replace damaged parts with original equipment parts. Every three years, have an authorized service person inspect the blade or replace the old blade with an original equipment part. This will extend the life of the product and is also necessary to maintain warranty coverage. Check the spark plug, drive brake, lubricate the unit, and clean the air filter once a year. Follow the Maintenance section to keep the unit in good operating condition. WARNING: Before you make an inspection, adjustment, or repair to the unit, disconnect the wire to the spark plug. Remove the wire from the spark plug to prevent the engine from starting by accident. [. . . ] A correct replacement part or assistance is available from an Authorized Service Centre in your area. Bend the ends of the cotter pin (5) apart to keep the front wheel (1) on the spindle (3). CAUTION: If the unit is operated in dry areas that have sand, use a dry graphite spray to lubricate the unit. NOTE: Make sure the lift lever (1) is locked in the LEVEL ADJUSTMENT position (2). [. . . ]